Debugging xAPI statements using SmartTracker

1. Click Preview.
2. Check Enable SmartTracker then click View Log.
   
3. You can see the xAPI statements descriptions in the log. For example, in the image below, we can see that the lesson titled "Sample Lesson" was launched; the page named "Introduction" was experienced; and "Question 1" was answered.
   
4. To see the low level data, click the expand icon.
   
5. In the example below, we can see that the learner scored 50% on the quiz.
   

   Note In preview debugging mode, the actor (learner) is not registered in the LRS so the actor will default to "lrs guest".